Avidyne Homepage
Forum Home Forum Home > Avidyne General > EX-Series Multi-Function Displays
  New Posts New Posts RSS Feed - Change Fuel Flow Parameter.
  FAQ FAQ  Forum Search   Register Register  Login Login

Change Fuel Flow Parameter.

 Post Reply Post Reply
Author
Message
Lance 33 View Drop Down
Newbie
Newbie
Avatar

Joined: 24 Apr 2020
Location: Australia
Status: Offline
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote Lance 33 Quote  Post ReplyReply Direct Link To This Post Topic: Change Fuel Flow Parameter.
    Posted: 25 Apr 2020 at 8:49pm
In my Cirrus   SR20 I have recently had my Engine Fuel Flow on Take off increased to 19.2 gph.
So now on every take off I see a red alert because 19.2 is higher than Fuel Flow parameter set in MFD.

Have been into MFD Aux page but cannot see where to adjust FF Parameter?

Any suggestions please?
Thanks
Lance

Lance
Back to Top
AviSteve View Drop Down
Admin Group
Admin Group
Avatar

Joined: 12 Feb 2018
Location: Melbourne, FL
Status: Offline
Points: 2244
Post Options Post Options   Thanks (0) Thanks(0)   Quote AviSteve Quote  Post ReplyReply Direct Link To This Post Posted: 26 Apr 2020 at 2:45pm
That value is not user configurable.  During MFD development, it was imposed/specified by the manufacturer.
Steve Lindsley
Avidyne Engineering
Back to Top
Lance 33 View Drop Down
Newbie
Newbie
Avatar

Joined: 24 Apr 2020
Location: Australia
Status: Offline
Points: 7
Post Options Post Options   Thanks (0) Thanks(0)   Quote Lance 33 Quote  Post ReplyReply Direct Link To This Post Posted: 26 Apr 2020 at 8:37pm
Thanks Steve.
Lance
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Forum Software by Web Wiz Forums® version 12.01
Copyright ©2001-2018 Web Wiz Ltd.

This page was generated in 0.125 seconds.